Not Just a Cable — The Communication Link Between Your ECU and Computer.
The aRacer PRO-LINK USB Communication Adapter is required to connect supported aRacer ECU systems to a PC for tuning, setup, calibration, and communication.
What It Is
PRO-LINK may look like a simple USB cable, but it includes an internal communication adapter module inside the connector housing. This module translates communication between your computer and supported aRacer ECU systems, similar in concept to a CAN bus or serial communication interface.
What It Does
- Connects supported aRacer ECUs to a computer
- Enables ECU setup, tuning, calibration, and configuration
- Provides communication between aRacer tuning software and supported ECU systems
- Includes an internal communication adapter module inside the connector housing
- Supports firmware, calibration, and diagnostic communication where applicable
- Designed specifically for supported aRacer ECU platforms
Why It Matters
Because PRO-LINK contains active communication electronics, it should not be treated as an ordinary USB cable. A generic USB cable cannot replace the PRO-LINK adapter. The internal module is what allows the computer and ECU to communicate correctly.
Compatibility
Compatible with supported aRacer ECU systems. Please verify compatibility with your ECU before ordering.
North American Support
- Supported by aRacer ECU R&D of America LLC
- U.S.-based technical support
- North American validation and platform development
- Fast domestic shipping from California when in stock
Competition Use Notice: Some products are intended for closed-course competition use only where applicable. Customer is responsible for compliance with all applicable laws and regulations.
California Proposition 65 Warning
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
